(沈阳建筑大学土木工程学院， 沈阳 110168)

［摘要］针对现有需要多次组模浇筑的固定模位式复合墙板模具拆卸困难、内叶墙模具达不到使用寿命和每套模具只能生产一种墙板等缺点，采用三维设计软件SKETCHUP与AUTOCAD平面制图相结合的设计方法对固定模位式复合墙板模具进行设计，并采用SAP2000软件对所设计的复合墙板模具受力状态进行计算模拟分析，对其底模及底模支架和内叶墙模具的承载力和刚度进行校核。复合墙板模具在模拟计算分析过程中，其承载力和刚度均满足相应标准。通过计算模拟分析表明：设计的模具能在各种工况条件下正常使用。

［关键词］复合墙板； 模具； 承载力； 刚度

中图分类号： TU398    文献标识码： A    文章编号： 1002-848X(2015)S2-0509-04

Simulation calculation analysis of composite wallboard mould design

Xu Chunyi, Zhao Huan, Chen Fengchuang

(Civil Engineering College, Shenyang Jianzhu University, Shenyang 110168, China)

Abstract: In view of shortcomings of composite wallboard mould in fixed mode type of multiple assembly mould pouring, inner lobe mould can not reach life, each mold can only produce a wallboard and so on, the fixed mode composite wallboard mould was designed combining three-dimensional design software SKETCHUP and AUTOCAD. Thestress state of composite wallboard mould was calculated and analyzed using the SAP2000 software, the bearing capacity and stiffness of each part of thebottom mould and bottomm stent and inner lobe mould of composite wallboard in fixed mode type were checked. In the process of simulation calculation analysis of composite wallboard mould, bearing capacity and stiffness meet the corresponding standards. Simulation calculation analysis shows that the composite wallboard mould design can be normally used in all kinds of conditions.

Keywords: composite wallboard; mould; bearing capacity; stiffness

作者简介：徐春一，硕士生导师，副教授，Email：xuchunyiyi@163.com。