- 摘 要
-
黄 崑 杨发云 (香港大学土木工程系)
[提要] 对6个不同构造方式的1:2的梁柱节点试件进行反复循环荷载下试验研究。结果表明,与传统的箍
筋相比,附加节点斜筋能和梁筋有限度地共同工作,从而将塑性铰从柱面转移。这样改善了钢筋的粘结状况,避免中等延性范围内纵筋的屈服向节点核心区扩展,地震能量被更有利的耗散机制吸收。同时,斜筋使节点本身的强度和刚度也得到进一步加强。结果可供中等烈度区抗震设计时参考。
[关键词] 钢筋混凝土 梁柱节点 塑性铰 斜钢筋A new detailing of joint reinforcement, i.e. additional diagonal bars, is proposed and studied. Six half-size interior beam-column subassemblages are tested under reversed cyclic loading. Based on the test results,it is found that the additional diagonal bars can work together with the longitudinal bars and succeed in moving the plastic hinge from the column face. As a result, the bond condition is improved, and the joint core could be prevented from yielding penetration up to a moderate ductility level. The earthquake energy is thus dissipated more favorably. In addition, because of the presence of the inclined steel portion in the joint, the strength and stiffness of the joint panel are improved as well.
Keywords: reinforced concrete; beam-column joint; plastic hinge; diagonal bars参 考 文 献1. Filippou F C, Popov E P, Bertero V V. Effects of bond deterioration on hysteretic behavior of reinforced concrete joint.s. Report No.UCB/EERC-83/19, Earthquake Engineering Research Center, University of California, Berkeley, California, 1983: 184.
2. NZS 3101. Part l: The design of concrete structures and part 2:Commentary on the design of concrete structures. Standards New Zealand, Wellington, 1995: 520.
3. Abdel-Fattah B, Wight J K. Study of moving beam plastic hinging zones for earthquake-resistant design of R/C builc[ings. ACI Structural Journal, Jan.-Feb. , 1987: 31-39.
4. Paulay T, Priestley M J N. Seismic design of reinforced concrete and masonry buildings. J. Wiley & Sons, New York, 1992.
5. BSI, BS 8110. Structural use of concrete, Part l. British Standards Institution, 1997.
6. Cheung P C. Seismic design of reinforced concrete beam-column joints with floor slab. Research Report, 91( 4), Department of Civil Engineering, University of Canterbury, Christchurch, 1991.
7. Popov E P. Bond and anchorage of reinforcing bars under cyclic loading. ACI Journal, 1984, 81(4).
8. Yang S S, Chen J K. Bond slip and crack width calculations of tension members. ACI Structural Journal, 1988, 85(4).