［摘要］进行了两组双钢板-混凝土组合剪力墙拟静力抗震性能试验，研究了该类结构的受力机理，并得到其典型破坏形态。试件均表现出良好的延性和耗能能力，滞回曲线饱满稳定，极限位移角均超过现行规范的规定限值，且大于其他类似试验的结果。缀板拉结措施可有效避免墙身钢板的局部屈曲，同时可加强对内填混凝土的约束作用，使高强混凝土在抗震剪力墙中的应用成为可能，从而很好地满足了超高层建筑结构对剪力墙“高轴压、高延性、薄墙体”的设计需求。在试验研究的基础上，开展了理论分析和数值模拟，对双钢板-混凝土组合剪力墙在工程中的应用提出了初步设计建议，对有待进一步开展的研究工作进行了展望。研究表明，双钢板-混凝土组合剪力墙具有延性好、耗能能力强、构造简单、施工方便、避免裂缝外露等优点，在超高层建筑结构中具有广阔的应用前景。
［关键词］双钢板-混凝土组合剪力墙；抗震性能；拟静力试验；延性；超高层建筑；设计建议
中图分类号：TU398+.2，TU317+.1文献标识码：A文章编号：1002-848X(2011)12-0052-09
Research advances of composite shear walls withdouble steel plates and filled concrete
Nie Jianguo1, Tao Muxuan1, Fan Jiansheng1, Bu Fanmin1, Hu Hongsong1, Ma Xiaowei1，Li Shengyong2, Liu Fujun2(1 Key Laboratory of Civil Engineering Safety and Durability of China Education Ministry, Department of Civil Engineering, Tsinghua University, Beijing 100084, China; 2 RBS Architecture Engineer Design Associates, Guangzhou 510170, China)
Abstract:Quasi-static tests on seismic behavior of two groups of composite shear walls with double steel plates and filled concrete were conducted to investigate the structural mechanism and the typical failure modes. In the tests, all the specimens illustrated good ductility and energy dissipation ability with stable and full hysteretic curves. The ultimate drifts of all the specimens exceeded the limit value recommended by the current design code, and were also larger than the similar test results provided by other researchers. Batten plates tied the double steel plates can effectively prevent the steel plates from local buckling and enhanced the confining effect on the infill concrete. As a result, the high-strength concrete can be used in seismic shear wall structures and the design requirements of ‘high compression, high ductility and small thickness’ for shear walls in super high-rise buildings can be fully satisfied. Based on the experimental research, theoretical analysis and numerical simulation were conducted, and the preliminary design recommendations for the application of the composite shear wall with double steel plates and filled concrete were further presented. The research work to be further conducted was finally proposed. From this research, it can be concluded that since the composite shear wall with double steel plates and filled concrete has good ductility, superior energy dissipation ability, and simple details requiring convenient construction methods and avoiding the exposure of concrete cracks, it has wide application prospect in super high-rise buildings.
Keywords:composite shear wall with double steel plates and filled concrete; seismic behavior; quasi-static test; ductility; super high-rise building; design recommendation
*国家自然科学基金资助项目（51178246），清华大学自主科研计划资助项目（20101081766）。
作者简介：聂建国，博士，教授，Email:niejg@mail.tsinghua.edu.cn。
参考文献
［1］日本建筑构造技术者协会. 日本结构技术典型实例100选［M］. 北京: 中国建筑工业出版社, 2005.
［2］ 李国强, 张晓光, 沈祖炎. 钢板外包混凝土剪力墙板抗剪滞回性能试验研究［J］. 工业建筑，1995, 25(6): 32-35.
［3］ 陆烨, 李国强, 孙飞飞. 大高宽比屈曲约束组合钢板剪力墙的试验研究［J］. 建筑钢结构进展, 2009,11 (2): 18-27.
［4］ ASTANEH-ASL A. Seismic behavior and design of composite steel plate shear walls［R］. Steel Tips Report. Structural Steel Educational Council, 2002.
［5］ 蔡克全, 林盈成, 林志翰. 钢板剪力墙抗震行为与设计［C］//第四届海峡两岸及香港钢结构技术交流会论文集, 上海, 2006: 108-116.
［6］ 吴志坚. 钢板剪力墙和组合剪力墙的抗剪静力性能［D］. 哈尔滨: 哈尔滨工业大学, 2006.
［7］ HITAKA T, MATSUI C, SAKAI J. Cyclic tests on steel and concrete-filled tube frames with slit walls［J］. Earthquake Engineering & Structural Dynamics, 2007, 36(6): 707-727.
［8］ 高辉. 组合钢板剪力墙试验研究与理论分析［D］. 上海: 同济大学, 2007.
［9］ 干淳洁. 内置钢板钢筋混凝土剪力墙抗震性能研究［D］. 上海: 同济大学, 2008.
［10］ 管娜, 张素梅, 郭兰慧, 等. 两边连接钢板混凝土组合剪力墙试验研究与理论分析［C］//庆祝刘锡良教授八十华诞暨第八届全国现代结构工程学术研讨会，天津，2008.
［11］ 孙建超, 徐培福, 肖从真, 等. 钢板-混凝土组合剪力墙受剪性能试验研究［J］. 建筑结构, 2008, 38(6): 1-5.
［12］ WRIGHT H D. The behavior of composite walling under construction and service loading［J］. Journal of Constructional Steel Research, 1995, 35(3): 257-277.
［13］ WRIGHT H D. The axial load behaviour of composite walling［J］. Journal of Constructional Steel Research, 1998, 45(3): 353-375.
［14］ ANWAR HOSSAIN K M, WRIGHT H D. Experimental and theoretical behavior of composite walling under in-plane shear［J］. Journal of Constructional Steel Research, 2004, 61(6): 59-83.
［15］ LINK R A, ELWI A E. Composite concrete-steel plate walls: analysis and behavior［J］. Journal of Structural Engineering, ASCE, 1995, 121(2): 260-271.
［16］ EMORI K. Compressive and shear strength of concrete filled steel box wall［J］. Steel Structures, 2002, 68(2): 29-40.
［17］ PRYER J W. The development and use of British Steel Bi-Steel［C］ //Proceedings of the Eighth International Offshore and Polar Engineering Conference, Montreal, Canada, Int Soc Offshore & Polar Engineers, 1998: 173-178.
［18］ MASAHIKO O, SHODO A, HIROSHI O, et al. Study on steel plate reinforced concrete panels subjected to cyclic in-plane shear［J］. Nuclear Engineering and Design, 2004, 228(1-3): 225-244.
［19］ EOM T S, PARK H G, LEE C H, et al. Behavior of double skin composite wall subjected to in-plane cyclic loading［J］.Journal of Structural Engineering, ASCE, 2009, 135(10): 1239-1249.
［20］ GB 50011—2010建筑抗震设计规范［S］. 北京: 中国建筑工业出版社, 2010.
［21］ 唐九如. 钢筋混凝土框架节点抗震［M］. 南京: 东南大学出版社, 1989.
［22］ EN 1994-1-1: 2004. Eurocode 4. Design of composite steel and concrete structures. Part1-1. General rules and rules for buildings［S］. European Committee for Standardization, Brussels, Belgium, 2004.
［23］ GB 50017—2003钢结构设计规范［S］. 北京: 中国计划出版社, 2003.
［24］ 聂建国, 李法雄. 钢-混凝土组合板单向受压稳定性研究［J］. 中国铁道科学, 2009(6): 27-32.