（1 中国航空规划建设发展有限公司，北京 100120; 2 清华大学，北京 100084）
［摘要］在有限元分析模型得到充分验证的基础上，对北京A380机库大门桁架进行了降高度分析。分析结果表明：大跨度维修机库大门桁架受力最大、最不利杆件集中分布在桁架跨中负弯矩区，此处的设计是机库大门桁架设计的关键；综合采用预应力钢结构和钢与混凝土组合结构技术可以有效地降低A380机库大门桁架高度，但桁架高度降到8m以下时，自重和用钢量将会比原设计方案增加较多,且施工比较困难；A380机库大门桁架高度不小于8m时，降低跨中立柱高度有助于改善大门桁架受力，使跨中支座处下弦杆中混凝土灌注量小，自重轻，弦杆截面过渡平缓。提出了超大跨度机库屋盖大门桁架优化设计方案。
［关键词］超大跨度机库；大门桁架；降高度；优化设计方案
Study on optimized scheme of the gate truss of long-span hangar
Guo Peng1,2, Shen Shungao1, Zhu Dan1, Nie Jianguo2, Xu Qingkui1(1 China Aviation Planning and Construction Development Co., Ltd., Beijing 100120, China;  2 Tsinghua University, Beijing 100084, China)
Abstract:After the finite element analysis model has been validated, the analysis on lowering the gate truss height of A380 hangar in Beijing is carried out. The analysis results show that the most unfavorable members of the long-span hangar gate truss distribute concentratively in the mid-span negative moment region of the truss, where is the key part of the design of the hangar gate truss; the gate truss height of A380 hangar can be lowered effectively by using the prestressed steel structure technology and the steel-concrete composite structure technology synthetically, but when the truss height is below 8m, the deadweight and steel consumption will be more than that of the original design scheme, and the construction is difficult; when the gate truss height of A380 hangar is above 8m, lowering the mid-span column helps to improve the internal force distribution of the gate truss, which causes the concrete in the bottom chord of the gate truss at the mid-span support decreasing, the deadweight of the gate truss lightening and the chord section changing gently. The optimized design scheme of long-span hangars is proposed.
Keywords:long-span hangar; gate truss; lowering height; optimized design scheme
作者简介：郭鹏(1981-)，男，汉族，陕西铜川人，博士后，Email:guopeng123470@163.com。
参考文献
［1］沈顺高. 大跨度机库方案的概念设计与动力性能研究［D］. 北京：清华大学，2002.
［2］朱丹, 裴永忠, 徐瑞, 等.首都机场A380 机库的结构方案优化［J］. 建筑结构, 2006,36(S1):39-42.
［3］朱丹，裴永忠，徐瑞, 等. 北京A380机库大跨度结构设计研究［J］. 土木工程学报，2008,41(2): 1-8.
［4］GB50009—2001建筑结构荷载规范［S］.北京：中国建筑工业出版社，2001.
［5］CECS212:2006 预应力钢结构技术规程［S］.
［6］GB50017—2003 钢结构设计规范［S］.北京：中国计划出版社，2003.
［7］钟善桐. 预应力钢结构［M］. 哈尔滨：哈尔滨工业大学出版社，1986.