（1 华南理工大学土木与交通学院， 广州 510641； 2 亚热带建筑科学国家重点实验室， 广州 510641； 3 澳大利亚新南威尔斯大学土木与环境学院CIES研究中心, 悉尼 NSW 2052）

［摘要］为了解新型钢管混凝土柱-混凝土梁节点在地震后的力学性能，对经历了低周反复荷载作用的节点试件进行轴压试验，探讨该新型节点在轴压荷载作用下的破坏形态、极限承载力及其应变特点。试验结果表明，试件在轴压过程出现两种不同的破坏形式，其中节点截面尺寸较小的试件表现为节点的破坏，而节点截面尺寸较大的试件则表现为柱钢管屈曲失效，并明确两种不同的破坏形式中，节点钢筋网在震后带损伤的情况下仍能够充分发挥其强度，节点在钢筋网约束与扩大横截面的局压受力机理作用下其承载力得到提高。通过合理设计的新型节点的承载力可高于钢管混凝土柱的承载力，可实现“强节点，弱构件”的抗震理念。

［关键词］钢管混凝土柱-混凝土梁节点; 不贯通钢管; 轴心受压

中图分类号：TU398  文献标识码：A  文章编号：1002-848X(2014)04-0015-06

Axial compression experimental research on the new type concrete-filled steel tubular column-concrete beam joint after cyclic loadings

Chen Qingjun1,2,3, He An1, Cai Jian1,2, Tang Xulin1, Zhang Yulin1

(1 School of Civil and Transportation Engineering, South China University of Technology, Guangzhou 510641, China; 2 State Key Laboratory of Subtropical Building Science, Guangzhou 510641, China; 3 Centre for Infrastructure Engineering and Safety, School of Civil and Environmental Engineering, The University of New South Wales, UNSW, Sydney NSW 2052, Australia)

Abstract: In order to investigate the mechanical behavior of the new type concrete-filled steel tubular column-beam joint after earthquake, the axial compression experiment was carried out on specimens after cyclic loadings. The failure modes, the ultimate bearing capacity and the features of the strains were discussed. The results indicate that two failure modes occur in the test. For specimen joints with small cross section, failure region is concentrated within the joint. On the contrary, for those with larger cross section, failure is the buckling of concrete-filled steel tubular column. After the earthquake, the mat reinforcement of joints can still give full play to its strength and the capacity of the joints increases by the confinement of mat reinforcement and local compressive effect of the enlarged cross section. Through the reasonable design, the bearing capacity of the joint zone is higher than concrete-filled steel tubular column, which meets the seismic design requirement of weak member and strong joint.

Keywords: concrete-filled steel tubular column-beam joint; discontinuous steel tube; axial compression

*华南理工大学亚热带建筑科学国家重点实验室自主研究课题项目(2013ZC19)，中央高校基本科研业务费专项资金资助项目(2014ZZ0026)，广东省自然科学基金资助项目(9451064101002910)。

作者简介：陈庆军，博士，副教授，Email:qjchen@scut.edu.cn。

参考文献

［1］EIICHI INAI, AKIYOSHI MUKAI, MAKOTO KAI. Behavior of concrete-filled steel tube beam columns ［J］. Journal of Structural Engineering, 2004, 130(2):189-202.

［2］VARMA AMIT H, RICLES JAMES M, RICHARD SAUSE. Seismic behavior and design of high-strength square concrete-filled steel tube beam columns ［J］. Journal of Structural Engineering, 2004, 130(2):169-179.

［3］蔡健,黄泰赟. 高层钢管混凝土柱节点的应用现状和存在问题［J］. 建筑结构,2001,31(7):8-10.

［4］陈庆军,蔡健,林遥明,等. 柱钢管不直通的新型钢管混凝土柱-梁节点(I)轴压下采用钢筋网加强钢管不直通的节点区的性能［J］. 华南理工大学学报：自然科学版, 2002,30(9):91-99.

［5］陈庆军,蔡健,林遥明,等. 柱钢管不直通的新型钢管混凝土柱-梁节点(Ⅱ)轴压下采用环形钢筋加强钢管不直通的节点区的性能［J］. 华南理工大学学报：自然科学版，2002,30(12):58-61.

［6］陈庆军,蔡健,杨平,等. 节点区柱钢管不贯通式钢管混凝土柱-梁节点抗震性能［J］. 土木工程学报, 2009,42(12):33-42.

［7］陈庆军, 蔡健, 徐刚,等. 节点区柱钢管不全贯通式钢管混凝土柱-梁节点区的受压试验研究［J］. 华南理工大学学报：自然科学版，2008,36(6):10-16.

［8］段伟宁. 钢筋网约束不贯通式矩形钢管混凝土柱-梁节点轴压性能的基础研究［D］. 广州:华南理工大学, 2012.

［9］HARADA Y, MORITA K. Design of wide-flange section column-to-split-tee tensile connection with high-strength bolts［J］. Journal of Structural Engineering, ASCE, 2007, 133(2):335-346.

［10］张津. 钢筋网约束的不贯通式矩形钢管混凝土柱-梁节点偏压性能基础研究［D］. 广州:华南理工大学, 2013.

［11］GB 50010—2010混凝土结构设计规范［S］. 北京:中国建筑工业出版社, 2011.